Sleeve Inspecting Machine

1. Main body unit
1). Machine’s main body adopts steel structure.
2). Main driving roller adopts seamless steel pipe (after tempering, surface hardening, chrome plated,mirror surface, dynamic balance treatment)
3). Main driving press roller adopts rubber roll (nitrile-butadiene rubber)
4). Material guide rollers adopts steel rolls (aluminum alloy)
2. Unwinding unit
1). Unwind unit adopts one-piece structure.
2). It adopts removable bracket with ball slider.
3). shaft adopts 3 inch air shaft
4). 1 set bias adjustable device can fine tune left and right, forward and backward through hand wheel.
5). Unwind tension’s actuator is 1 set magnetic powder brake. through PLC and load cell to achieve a close loop tension.
6). EPC uses BIANFU Brand corrective device, it can achieve guide function by material’s edge.
3. Rewinding unit
1). Shafts adopt 3 inch air shaft.
2). Rewind tension’s actuator is 1 set servo motor and driver. Through PLC to do the automatic tension control.
4. Electrical equipment unit
1). Main motor driver adopts 1 pc BOSCH REXROTH Germany brand inverter
2). Main motor adopts 1 pc Taiwanese brand Danma servo motor.
3). Rewind motor driver adopts 1 pc BOSCH REXROTH, Germany brand inverter
4). Rewind motor adopts 1 pc Taiwanese brand Danma servo motor.
5). EPC adopts analog control. Driving by servo motor through ultrasonic sensor.
6). Adopts imported PLC to achieve accurate and stable control, true color touch screen display to enable simple and beautiful images. Interactive parameter setting the environment, eliminating the complicated configuration can start the job: The user pre-start only need to input the material thickness, width, density, diameter and speed parameters, the next will be done automatically by a computer calculation to complete.
7). With the functions of automatic and manual acceleration and deceleration.